Output:external:pulse:perwid, Output:external:pulse:source, Output:external:signal – Boonton 4540 Peak Power Meter User Manual User Manual

Page 174: Output:internal:level[:power, Output:external:pulse:perwid -40, Output:external:pulse:source -40, Output:external:signal -40, Output:internal:level[:power] -40, Boonton 4540 series rf power meter, Remote operation

Boonton 4540 Series RF Power Meter

Remote Operation

5-40

OUTPut:EXTernal:PULse:PERWID

Description:

Set or return the pulse period and pulse width in seconds in the Variable pulse
control mode of the external 1 GHz calibrator. This parameter has no effect in the preset pulse
control mode or the external pulse source mode.

Syntax:

OUTPut:EXTernal:PULse:PERWID

Argument:

= 28e-6 to 131.07e-3 (Pulse period)

= 7e-6 to 65.535e-3 (Pulse width)

Valid Modes:

Any

OUTPut:EXTernal:PULse:SOURce

Description:

Set or return the pulse modulation source for the external 1 GHz calibrator. If set to INT, the
internal pulse generator is used. EXT selects the signal from the calibrator’s rear-panel EXT
PULSE input. Note this input requires TTL compatible signal levels.

Syntax:

OUTPut:EXTernal:PULse:SOURce

Argument:

= {INT, EXT}

Valid Modes:

Any

OUTPut:EXTernal:SIGNal

Description:

Set or return the on/off state of the external 1 GHz calibrator output signal.

Syntax:

OUTPut:EXTernal:SIGNal

Argument:

= { 0, 1, OFF, ON }

Valid Modes:

Any

OUTPut:INTernal:LEVel[:POWer]

Description:

Set or return the power level of the internal 50 MHz calibrator output signal.

Syntax:

OUTPut:INTernal:LEVel:POWer < numeric_value >

Argument:

= -60.0 to +20.0 dBm (0.1dB resolution)

Valid Modes:

Any