Boonton 4540 Peak Power Meter User Manual - Manual (Page 204)

Boonton 4540 Series RF Power Meter
Remote Operation 5-70
5.6.15 SYSTem Subsystem
The SYSTem group of commands is used to control system-level functions not directly related to instrument measurement
performance. SYSTem commands are used to return error codes or messages from the power meter error queue, control
hardware features (backlight and key beep), access the internal clock/calendar, and configure communication parameters for
the GPIB and LAN interfaces.
SYSTem:AUTOSET
Description: Perform the Auto Setup function to acquire a signal and display the trace in the Pulse Mode.
Syntax: SYSTem:AUTOSET
Argument: None
Valid Modes: Pulse Mode is forced if not already set.
SYSTem:BEEP[:ENABle]
Description: Set or return the status of the audible keyboard beeper.
Syntax: SYSTem:BEEP[:ENABle]
Argument: = { 0, 1, OFF, ON }
Valid Modes: Any
SYSTem:BEEP:IMMediate
Description: Causes the system to emit an audible beep. Command only; does not respond to a query.
Syntax: SYSTem:BEEP:IMMediate
Argument: None
Valid Modes: Any
SYSTem:COMMunicate:GPIB:ADDRess
Description: Set or return the GPIB bus address.
Syntax: SYSTem:COMMunicate:GPIB:ADDRess
Argument: = 1 to 30
Valid Modes: Any