HP Onboard Administrator - Manual (Page 97)

Configuring the HP BladeSystem c7000 enclosure and enclosure devices 97
• Informational
Enclosure settings
Selecting enclosures
The primary interlink ports are displayed in the rack topology table. The primary enclosure is selected by
default, and cannot be deselected.
When linked enclosures are displayed, the topology mode that the application uses during your session is
determined by the check box selections made before signing in, as described below:
• Local Mode—This is the default topology mode, and is enabled if none of the linked enclosures are
selected. All topology changes that occur while signed in are ignored by the application.
• Fixed Mode—This topology mode is enabled when some of the linked enclosures are selected, but not
all of them. Only topology changes that affect the selected enclosures while signed in are displayed by
the application.
• Linked Mode—This topology mode is enabled if all displayed enclosures are selected. All topology
changes that occur while signed in are displayed by the application.
Enclosure Settings screen
The Enclosure Settings screen provides detailed procedures to configure the management functionalities
provided by the Onboard Administrator.
To view the enclosure Status screen from the tree view, select Enclosure Information.
Enclosure Status tab
Status information
Row Description
Enclosure Status The overall status of the enclosure. Possible values are Unknown, OK, Degraded, N/A,
or Critical Error.*
Active OA Status The overall status of the Active Onboard Administrator. Possible values are Unknown,
OK, Degraded, or Failed.