HP Onboard Administrator - Manual (Page 105)

Configuring the HP BladeSystem c7000 enclosure and enclosure devices 105
Device Bays Standard tab and Double Dense tabs
The Device Bays Standard tab indicates the current settings for all the primary bays based on the type of
enclosure. To change a setting on a particular device bay, use the menu under the Enabled column and select
Enabled, Disabled or No Poweron. If Enabled is selected, a power delay in seconds must be entered in the
Delay column for this bay. The minimum value is 1 second; the maximum value is 3600 seconds.
If double dense servers are installed in an enclosure the power delay settings for Side A and Side B are
controlled in the Double Dense Side A and Double Dense Side B tabs.
Interconnect Bays tab
Interconnect bays by default are for auto power-on. Enabling and setting a power delay for an interconnect
bay delays the power on of that bay following an enclosure power cycle event.
Column Description
Bay Bay number of the device.
Device The type of device in the bay, or Absent if no device is installed in the bay
Enabled Enables power sequencing, disables power sequencing, or does not allow powering
on of the device if No Poweron is selected.
Delay The amount of delay, in seconds, before the device powers on.