HP Onboard Administrator User Manual
Page 103
Configuring the HP BladeSystem c7000 enclosure and enclosure devices 103
o
Blade fault
o
Blade information change
o
Tray status change
o
Tray reset
o
Switch connect
o
Switch disconnect
All e-mails have the following header:
From: Enclosure ENCLOSURE-NAME
Date: Date in standard format
Subject: HP AlertMail-SEQ:
To: RECEIVER MAILBOX
Where SEVERITY is one of the following (from highest to lowest):
o
# FATAL
o
# CRITICAL
o
# WARNING MAJOR
o
# WARNING MINOR
o
# WARNING
o
# NORMAL
Each subject line contains a unique sequence number to easily identify the order of events in case the mail
server distributes them in the wrong order. Sequence numbers range from 0 to 999 and start again at 0.
The mail body is used to give more detailed information regarding the event issued. It also contains
information on what the user should do to correct any issue and what the current enclosure status is.
NOTE:
The enclosure status is displayed as the status at the time the event was processed which
can cause the status to show up as OK in an e-mail saying a Fan has Failed, if the user has already
replaced the fan at the time the event was sent out by AlertMail.
Sample e-mail
Subject: HP AlertMail-010: (CRITICAL) Power Supply #1: Failed
Date: Wed, 23 Apr 2006 15:02:22 +0200
From: Enclosure EM-00508BEBA571 <[email protected]>
To: user@domain
X-OS: HP BladeSystem Enclosure Manager
X-Priority: 1
Content-Type: text/plain; charset=us-ascii
EVENT (26 May 07:09): Power Supply #1 Status has changed to: Failed.
Enclosure, EM-00508BEBA571, has detected that a power supply in bay 1 has
changed from status OK to Failed.
The power supply should be replaced with the appropriate spare part. You can
ensure that the center wall assembly is operating correctly by swapping the
two power supplies. Make sure that there are no bent pins on the power supply
connectors before reinserting and that each power supply is fully seated.
An amber LED on the power supply indicates either an over-voltage,
over-temperature, or loss of AC power has occurred. A blinking LED on the
power supply indicates a current limit condition.