HP StorageWorks XP Remote Web Console Software - Manual (Page 119)

2. In the LU Path or LDEV table, right-click the command device.
NOTE:
• If nothing appears in the LU Path table, select a host group ( ) in the tree.
• The icon indicates a logical volume to which command device security is already
applied.
• The icon does not indicate any logical device.
3. Select Cmd. Dev. Security: Disable -> Enable. A confirmation message appears.
4. Click OK.
5. Click Apply. A confirmation message appears.
6. Click OK. Settings are applied to the array.
NOTE:
To remove command device security from a logical device, right-click the logical device ( ) in the
LU Path or LDEV table, and select Cmd. Dev. Security: Enable -> Disable.
Defining remote command devices
A remote command device is a device in the array to which a command device in the external array
is mapped.
As you send RAID Manager XP commands to the remote command device, these RAID Manager XP
commands are sent to the external array's command device to perform RAID Manager XP operations
on the external array.
You can map a command device as a remote command device when one of the following arrays is
connected as an external array:
• XP12000 Disk Array
• XP10000 Disk Array
• HP 200 Storage Virtualization System
• XP1024/XP128 Disk Array
• XP12000 Disk Array subsystem
• XP10000 Disk Array subsystem
• TagmaStore Adaptable Modular Storage subsystem
• TagmaStore Workgroup Modular Storage subsystem
• XP512/XP48 Disk Array series
For more information about defining remote command devices, see the HP StorageWorks External
Storage XP user guide.
XP LUN Configuration and Security Manager User Guide 119