HP ProCurve 520wl Wireless Access Point - Manual (Page 98)

Set Basic Configuration Parameters using CLI Commands
6-15
set network names for each wireless interface set network names for each wireless interface set network names for each wireless interface set network names for each wireless interface
– 3 = wireless card in Slot A 4 = wireless card in Slot B
[Device Name]>set wif 3 netname
[Device Name]>set wif 4 netname
[Device Name]>show wif
Figure 6-12 Figure 6-12 Figure 6-12 Figure 6-12 Results of “show wif” CLI command Results of “show wif” CLI command Results of “show wif” CLI command Results of “show wif” CLI command
set wep encryption for each wireless interface set wep encryption for each wireless interface set wep encryption for each wireless interface set wep encryption for each wireless interface
– 3 = wireless card in Slot A
– 4 = wireless card in Slot B
CAUTION: !
Client stations must have the same encryption key to be able to communicate with the WL520 device. Each Wireless
Interface can only support one Key Length (so each of the configured keys must have the same length). The available
key sizes vary based on card type. See Set WEP Encryption for each Wireless Interface for more information.
for the wireless card in slot a for the wireless card in slot a for the wireless card in slot a for the wireless card in slot a
You can set up to four encryption keys. This example describes setting encryption Key 1 on the wireless card in Slot A.
[Device Name]>set wifsec 3 encryptstatus enable encryptkey1
(number of characters
vary depending on card type)> encryptkeytx 1
[Device Name]>show wifsec
for the wireless card in slot b for the wireless card in slot b for the wireless card in slot b for the wireless card in slot b
You can set up to four encryption keys. This example describes setting encryption Key 2 on the wireless card in Slot B.
[Device Name]>set wifsec 4 encryptstatus enable encryptkey2
(number of characters
vary depending on card type)> encryptkeytx 1
[Device Name]>show wifsec