Disable link integrity, Change your wireless interface settings, 11a wireless interface card – HP ProCurve 520wl Wireless Access Point User Manual

Page 26: Disable link integrity -13, Change your wireless interface settings -13, 11a wireless interface card -13

Change your Wireless Interface Settings

2-13

disable link integrity

To disable Link Integrity check for all clients, deselect the

Enable Link Integrity

check box.

To disable Link Integrity check to a certain host computer, click the

Edit

button in the

TTTTarget IP Address Table

arget IP Address Table

and set the

Status

Disable

change your wireless interface settings

Depending on the type of wireless PC Card installed in the WL520 device, the configuration options will be different. Some

parameters are the same for 802.11a and 802.11b cards. Others are unique to each card type.
You can setup an WL520 unit using the following combinations of wireless cards:

1. single 802.11a card with the attached antenna adapter
2. single 802.11b card
3. two 802.11b cards (one in each slot)
4. one 802.11a card with attached antenna and one 802.11b card

802.11a wireless interface card

Figure 2-14

Figure 2-14 802.11a Wireless Interface Options

802.11a Wireless Interface Options

–

Network Name

. Enter a Network Name for each PC Card. This is the same name used on client machines to connect using

the client configuration software. Range is 1 - 31 characters; default is “My Wireless Network A” for card in Slot A and

“My Wireless Network B” for card in Slot B.

–

Enable Auto Channel Select (ACS)

. By default this feature is enabled. The WL520 device scans the area for other WL520

devices and selects a free or relatively unused communication channel. This helps prevent interference problems and

increases network performance. Note that this option is not available for 802.11a products in Europe. See

Dynamic

Frequency Selection (DFS)

for more information. Default is enable.

–

Turbo Mode

Turbo Mode. . . .

An 802.11a card supports an extension of the IEEE 802.11a standard that provides twice the data rate. Note

that Turbo mode is not defined in the IEEE 802.11a specification. By default, Turbo mode is disabled. Turbo mode is not

available in all countries including European countries and Japan. Default is disable.

–

Frequency Channel

. If Auto Channel Select is disabled, use the pull-down menu to select the desired card frequency. Ensure

nearby devices do not use the same frequency. The Frequency Channels available will depend on the card type, card

mode (standard mode or Turbo mode), and the country of use. Refer to

Radio Specifications

for details.

–

Transmit Rate

. Use the pull-down menu to select a specific transmit rate for the 802.11a card. Choose between 6, 9, 12,

18, 24, 36, 48, 54 Mbits/s, or Auto Fallback for standard 802.11a mode. If Turbo mode is enabled, choose between 12,

18, 24, 36, 48, 72, 98, 108 Mbits/s, or Auto Fallback. The Auto Fallback feature allows the WL520 unit to select the best

transmit rate based on the cell size. Default is Autofallback.