Change your wireless interface settings, Enable/disable closed system, Enable/disable load balancing – HP ProCurve 520wl Wireless Access Point User Manual

Page 101: Enable/disable medium density distribution, Autochannel select (acs)

Other Network Settings

6-18

change your wireless interface settings

enable/disable interference robustness

– 3 = wireless card in Slot A
– 4 = wireless card in Slot B

[Device Name]>set wif <3

or 4> interrobust

This feature is only available for 802.11b wireless cards.

enable/disable closed system

– 3 = wireless card in Slot A
– 4 = wireless card in Slot B

[Device Name]>set wif <3 or 4> closedsys

NOTE:

When disabled, a client configured with the Network Name “ANY” can connect to the WL520. This feature is only

available for 802.11b wireless cards.

enable/disable load balancing

– 3 = wireless card in Slot A
– 4 = wireless card in Slot B

[Device Name]>set wif <3 or 4> ldbalance

This feature is only available for 802.11b wireless cards.

enable/disable medium density distribution

– 3 = wireless card in Slot A
– 4 = wireless card in Slot B

[Device Name]>set wif <3 or 4> meddendistrib

This feature is only available for 802.11b wireless cards.

autochannel select (acs)

ACS is enabled by default. In order to disable ACS, disable the cards in slots A and B and reboot.
– 3 = wireless card in Slot A
– 4 = wireless card in Slot B

[Device Name]>set wif <3 or 4> autochannel disable

[Device Name]>reboot 0

re-enable acs

– 3 = wireless card in Slot A
– 4 = wireless card in Slot B

[Device Name]>set wif <3 or 4> autochannel enable

[Device Name]>reboot 0