Editing tcp/udp port filters, Alarms (snmp traps), Alarm (trap) groups – HP ProCurve 520wl Wireless Access Point User Manual

Page 63: Alarm host table, Editing tcp/udp port filters -14, Alarms (snmp traps) -14, Alarm (trap) groups -14 alarm host table -14

Alarms (SNMP Traps)

4-14

editing tcp/udp port filters

1. In the Web Interface, click the

Configure

button and select the

Filtering

tab.

2. Select the

TCP/UDP Port

sub-tab.

3. Under the heading,

TCP/UDP Port Filter Table

, click the button marked

Edit

Edit.

4. Make any changes to the Protocol Name or Port Number for a specific entry, if necessary.
5. In the row that defines the port, set the

Status

enable

disable

, or

delete

as appropriate.

6. Select

OK.

alarms (snmp traps)

alarm (trap) groups

Figure 4-14

Figure 4-14 Alarm Groups Configuration Screen

Alarm Groups Configuration Screen

There are seven alarm groups that can be enabled or disabled:

There are seven alarm groups that can be enabled or disabled:
–

Enable Configuration Alarms

–

Enable Security Alarms

–

Enable Wireless Alarms

–

Enable Operational Alarms

–

Enable Flash Memory Alarms

–

Enable TFTP Alarms

–

Enable Image Alarms

. Place a checkmark in the box provided to enable a specific group. Remove the checkmark from the

box to disable the alarms.

See

System Alarms (Traps)

for the list of alarms contained in each group.

alarm host table

To add an entry and enable the WL520 to send SNMP trap messages to a Trap Host, click

Add

, and then specify the IP

Address and Password for the Trap Host.
–

IP Address

. Enter the Trap Host IP Address.

–

Password, Confirm

. Enter the password in the

Password

field and the

Confirm

field.

–

Comment

. Enter an optional comment, such as the alarm (trap) host station name.

– To edit or delete an entry, click

Edit

. Edit the information, or select

Enable

Enable, , , , Disable

Disable

, or

Delete

from the

Status

pull-down

menu.