HP ProCurve 520wl Wireless Access Point - Manual (Page 119)

Parameter Tables
6-36
syslog host table syslog host table syslog host table syslog host table
The table described below configures the Syslog hosts that will receive message from the WL520. You can configure up to ten
Syslog hosts. Note that you can only configure one Syslog host via the HTTP interface (row 1, which defaults to 10.0.0.2).
iapp parameters iapp parameters iapp parameters iapp parameters
NOTE:
These parameters configure the Inter Access Point Protocol (IAPP) for roaming. Leave these settings at their default
value unless a technical representative asks you to change them.
spectralink voip parameters spectralink voip parameters spectralink voip parameters spectralink voip parameters
name name name name type type type type values values values values access access access access cli parameter cli parameter cli parameter cli parameter
Syslog Host Table Table N/A R sysloghosttbl
Table Index Integer 1 – 10 N/A index
IP Address IpAddress User Defined RW ipaddr
Comment (optional) DisplayString User Defined RW cmt
Status (optional) Integer enable
disable
delete
RW status
name name name name type type type type values values values values access access access access cli parameter cli parameter cli parameter cli parameter
IAPP Group N/A R iapp
IAPP Status Integer enable (default)
disable
RW iappstatus
Periodic Announce Interval
(seconds)
Integer 80
120 (default)
160
200
RW iappannint
Announce Response Time Integer 2 seconds R iappannresp
Handover Time-out Integer 410 ms
512 ms (default)
614 ms
717 ms
819 ms
RW iapphandtout
Max. Handover
Retransmissions
Integer 1 - 10 (default 4) RW iapphandretx
Send Announce Request on
Startup
Integer enable (default)
disable
RW iappannreqstart
name name name name type type type type values values values values access access access access cli parameter cli parameter cli parameter cli parameter
Spectralink VoIP Group N/A R spectralink
Spectralink VoIP Status Integer enable
disable (default)
RW speclinkstatus