Wds setup procedure, Wds setup procedure -21 – HP ProCurve 520wl Wireless Access Point User Manual

Page 70

Wireless Distribution System (WDS)

4-21

wds setup procedure

NOTE:

WDS and ACS cannot be Enabled at the same time on the same card.

To setup a wireless backbone follow the steps below for each WL520 that you wish to include in the wireless distribution

system. Since WDS and ACS cannot be Enabled at the same time on the same card, the first step must be to ensure ACS is

disabled. Follow the process described in

Figure 4-23

Figure 4-23 Wireless Interface Screen - WDS Configuration

Wireless Interface Screen - WDS Configuration

1. Write down the MAC Address of the hp wireless PC Card WL110 inside the wireless slot of the WL520 that you wish to

include in the wireless distribution system (this value is printed on a label on the back of the WL110 PC Card).

2. In the Web Interface, click the

Configure

button and select

Interfaces

3. Select the

Wireless

Wireless sub-

sub-

tab that corresponds to the card’s location (slot A or B).

4. Click the

Edit

button to update the Wireless Distribution System (WDS) Table.