Set http interface management services, Configure serial port interface settings, Other security configuration settings – HP ProCurve 520wl Wireless Access Point User Manual

Page 33: Configure your mac (address) access control table, Other security configuration settings -20

Other Security Configuration Settings

2-20

set http interface management services

1. In the Web Interface, click the

Configure

button and select the

Management

tab.

2. Choose the

Services

sub-tab.

3. For each service, there is a list of associated settings. From the drop-down menu, select which physical interface(s) can be

used to manage the WL520 device using the Web interface. For example, to allow Web configuration via the Ethernet

network only, set HTTP Interface Bitmask

HTTP Interface Bitmask

HTTP Interface Bitmask to Ethernet

Ethernet

Ethernet. The available configuration options are:

— Disabled (all interfaces)
— Ethernet only enabled
— Wireless A only enabled
— Wireless B only enabled
— All Interfaces enabled

4. Enter the HTTP communication port number. Default is 80.

NOTE:

See

for information on the SNMP, Telnet, and other HTTP parameters

that can be configured from the Services screen.

configure serial port interface settings

The serial port interface on the WL520 device is enabled at all times. You can set the following parameters as needed:
–

Baud Rate

. Select the serial port speed (bits per second). Choose between 2400, 4800, 9600, 19200, 38400, or 57600;

the default Baud Rate is

9600

–

Flow Control

. Select either

None

(default) or

Xon/Xoff

(software controlled) data flow control.

NOTE:

To avoid unexpected performance of your WL520, leave the setting Flow Control to its default value (none) unless you

are sure what this setting should be.

other security configuration settings

Control access to the WL520 device using MAC Address authentication, WEP encryption, or 802.1x security settings.

configure your mac (address) access control table

Figure 2-20

Figure 2-20 Security Configuration Screen - MAC Authentication

Security Configuration Screen - MAC Authentication