Configuring management service interfaces, Configuring management service interfaces -10 – HP ProCurve 520wl Wireless Access Point User Manual

Page 59

Management Settings

4-10

configuring management service interfaces

Figure 4-9

Management Services Configuration Screen

snmp-based management interface bitmask

Configure the interface or interfaces (Ethernet, Wireless-A, Wireless-B, All Interfaces) from which you will manage the WL520

device via SNMP. You can also select Disabled to prevent a user from accessing the WL520 device via SNMP. Reboot the

WL520 for this setting to take effect.

http access

Several configuration options are available that restrict access to the Web interface. Reboot the WL520 for any changes to

take effect.
– HTTP Interface Bitmap.

HTTP Interface Bitmap.

HTTP Interface Bitmap. Configure the interface or interfaces (Ethernet, Wireless-A, Wireless-B, All Interfaces) from which

you will manage the WL520 device via the Web interface. You can also select Disabled to prevent a user from accessing

the WL520 device from the Web interface.

– HTTP Port.

HTTP Port.

HTTP Port. Configure the HTTP port from which you will manage the WL520 device via the Web interface. By default, the

HTTP port is 80.

telnet configuration settings

Use the Services tab to set the Telnet port, timeout, and session parameters.
–

Telnet Interface Bitmask

. Select the interface(s) (Disabled, Ethernet, Wireless A, Wireless B, All Interfaces) from which you

can manage the WL520 device via telnet. This parameter can also be used to Disable telnet management. Reboot the

WL520 for this setting to take effect.

–

Telnet Port

. Enter the Telnet Port. The default port number is 23.

–

. Enter the number of seconds the system will wait for a login attempt. The WL520 terminates

the session when it times out.

–

Session Idle Timeout (seconds)

. Enter the number of seconds the system will wait during a session while there is no activity.

The WL520 will terminate the session on timeout.

NOTE:

See

for information on the serial port parameters.