Dhcp ip pool table settings, Link integrity settings, Target ip address table settings – HP ProCurve 520wl Wireless Access Point User Manual

Page 52: Dhcp ip pool table settings -3, Link integrity settings -3, Target ip address table settings -3

Network Settings

4-3

dhcp ip pool table settings

To add an entry, click

Add

, and then specify the start and end IP Address.

–

Start IP Address

. Enter the starting IP Address for this IP Pool Table.

–

End IP Address

. Enter the ending IP Address for this IP Pool Table.

–

Comment

. Enter related information.

–

Default Lease Time (optional)

- the default time value for clients to retain the assigned IP Address. DHCP automatically

renews IP Addresses without client notification. Default is 86400 seconds.

–

Maximum Lease Time (optional)

- the maximum time value for clients to retain the assigned IP Address. DHCP automatically

renews IP Addresses without client notification. Default is 86400 seconds.

–

Status

. Shows enabled/disabled status.

To edit or delete an entry, click

Edit

. Edit the information, or select

Enable

Disable

, or

Delete

from the

Status

pull-down menu.

link integrity settings

This feature checks the link between the WL520 and connected network server(s). If the link goes down then the client will

connect to another WL520 in your network that still communicates with the server.

NOTE:

This feature is only applicable to 2.4 GHz (802.11b) cards.

Figure 4-2

Link Integrity Configuration Screen

–

Enable Link Integrity

. Place a check mark in the box provided to activate the Link Integrity feature.

–

Poll Interval

. Set the interval (minimum 500ms and in increments of 500ms) between polls.

–

Poll Retransmissions

. Set the number of times a poll should be retransmitted before the link is considered down.

target ip address table settings

To add an Target IP Address entry, click

Add

, and then specify the IP Address of the servers you want to check.

–

Target IP Address

. Enter the IP Address

–

Comments