Network settings, Advanced dhcp server configuration, Network settings -2 – HP ProCurve 520wl Wireless Access Point User Manual

Page 51: Advanced dhcp server configuration -2

Network Settings

4-2

network settings

advanced dhcp server configuration

Configure DHCP to provide dynamic client IP Addresses from one or more IP Pool Tables. Create IP Pool Tables by specifying a

Start IP Address and an End IP Address.

CAUTION:

Before enabling this feature, confirm that the IP address pools you have configured are valid addresses on the

network and do not overlap the addresses assigned by any other DHCP server on the network. Enabling this feature

with incorrect address pools will cause problems on your network.

Figure 4-1

DHCP Server Configuration Screen

–

Enable DHCP Server

. Place a check mark in the box provided to allow the WL520 to assign clients IP Addresses from IP Pool

Tables. Uncheck the box to prevent client IP Address assignment from the WL520.

NOTE:

You should have at least one entry in the DHCP Server IP Address Pool table before you enable the DHCP Server

feature.

–

Subnet Mask

. Read-only value of the WL520 mask.

–

Gateway IP Address

. Enter the default Gateway IP Address.

–

Primary DNS IP Address

. Enter the Domain Name Server IP Address.

–

Secondary DNS IP Address

. Enter the Domain Name Server IP Address.