HP ProCurve 520wl Wireless Access Point User Manual
Page 17
Figure 2-3
Figure 2-3
Figure 2-3
Configuration through the Web Interface
Configuration through the Web Interface
Configuration through the Web Interface
Figure 2-4
Figure 2-4
Figure 2-4
Configuration Options
Configuration Options
Configuration Options
O
OK
OK
C nc
Cancel
Cancel
1
2
3
Figure 2-3
Configuration through the Web Interface
You are now ready to configure each WL520 category, depending on your system. In some cases, you will not need to make
any changes. If you are in doubt about any setting, we recommend that you use the default values.
Figure 2-4
Configuration Options
To set properties for each category, click on the desired tab.
Result: The selected configuration screen appears. Each configuration screen allows you to select options, or enter, edit, and
delete information.
In some cases, the WL520 reminds you that it must be rebooted for a change to take effect. In a given session, you can wait to
reboot until all changes have been made. After entering or editing information on configuration screens, click OK to save
K
changes, or click Cancel to restore previous settings.
a el
You will want to set up a few basic configuration parameters right away when you receive the WL520 unit. For example:
– System name and location
– Contact information for network administrator
–
IP
Address
– Communication rules for your wireless interface(s)
– Passwords for the different management interfaces (SNMP, Telnet, HTTP)
– If you need to upload the latest software, you will also want to setup your TFTP server to communicate with the WL520
device. This process is described in downloading the latest software, under
.
2-4