Adding tcp/udp port filters, Adding tcp/udp port filters -13 – HP ProCurve 520wl Wireless Access Point User Manual

Page 62

Setting Filters

4-13

Figure 4-12

Figure 4-12 TCP/UDP Port Filtering Configuration Screen

TCP/UDP Port Filtering Configuration Screen

adding tcp/udp port filters

1. In the Web Interface, click the

Configure

button and select the

Filtering

tab.

2. Select the

TCP/UDP Port

sub-tab.

3. Click the box to

Enable TCP/UDP Port Filtering

Enable TCP/UDP Port Filtering.

4. Under the heading,

TCP/UDP Port Filter Table

, click

Add

Figure 4-13

Figure 4-13 Adding a Port to the TCP/UDP Port Filter Table

Adding a Port to the TCP/UDP Port Filter Table

5. In the

TCP/UDP Port Filter Table

TCP/UDP Port Filter Table,

enter the Protocol Names to filter.

6. Set the destination Port Number (a value between 0 and 65535) to filter. See the IANA Web site at

for a list of assigned port numbers and their descriptions.

7. Set the Port Type for the protocol: TCP, UDP, or both (TCP/UDP).
8. Set the

Interface

to filter (any combination of the following):

Wireless Slot A; Wireless Slot B; Ethernet

9. Click

NOTE:

Filters are enabled by default. Frames that the WL520 receives on the specified interface(s) with the specified

TCP/UDP destination port, are discarded.