HP ProCurve 520wl Wireless Access Point - Manual (Page 32)

Ethernet Settings
2-19
ethernet settings ethernet settings ethernet settings ethernet settings
set ethernet speed and transmission mode set ethernet speed and transmission mode set ethernet speed and transmission mode set ethernet speed and transmission mode
Figure 2-18 Figure 2-18 Figure 2-18 Figure 2-18 Ethernet Interface Ethernet Interface Ethernet Interface Ethernet Interface
Select the desired speed and transmission mode from the pull down menu. Half-duplex means that only one side can
broadcast at a time, full-duplex allows both sides to transmit, while auto-duplex selects the best transmission mode for the
given configuration. The recommended setting is auto-speed-auto-duplex auto-speed-auto-duplex auto-speed-auto-duplex auto-speed-auto-duplex . Choose between:
Q
10 Mbit/s - half duplex, full duplex, or auto duplex
Q
100 Mbit/s - half duplex, full duplex, or auto duplex
Q
auto speed - half duplex, auto duplex
configure your management interfaces configure your management interfaces configure your management interfaces configure your management interfaces
Select which interfaces will be available through the Wireless, Ethernet, and Serial Port interfaces of the WL520 unit.
Figure 2-19 Figure 2-19 Figure 2-19 Figure 2-19 Management Interface Settings Management Interface Settings Management Interface Settings Management Interface Settings