HP ProCurve 520wl Wireless Access Point - Manual (Page 100)

Other Network Settings
6-17
other network settings other network settings other network settings other network settings
There are other configuration settings that you may want to set for your WL520 unit. Some of them are listed below.
– Configure your WL520 device as a DHCP Server
– Maintain 802.11b Client Connections using Link Integrity
– Disable VLAN Management
– Change your Wireless Interface Settings
– Configure MAC Access Control
– Set RADIUS Parameters
NOTE:
Refer to Configuring Advanced Features for more complex network settings.
configure your wl520 device as a dhcp server configure your wl520 device as a dhcp server configure your wl520 device as a dhcp server configure your wl520 device as a dhcp server
NOTE:
You must have at least one entry in the DHCP Server client IP Address assignment table before you can enable the
DHCP Server Status feature.
[Device Name]>set dhcpstatus disable
[Device Name]>set dhcpippooltbl 0 startipaddr
endipaddr
[Device Name]>set dhcpgw
[Device Name]>set dhcppridnsipaddr
[Device Name]>set dhcpsecdnsipaddr
[Device Name]>set dhcpstatus enable
[Device Name]>reboot 0
CAUTION: !
Before enabling this feature, confirm that the IP address pools you have configured are valid addresses on the
network and do not overlap the addresses assigned by any other DHCP server on the network. Enabling this feature
with incorrect address pools will cause problems on your network.
maintain 802.11b client connections using link integrity maintain 802.11b client connections using link integrity maintain 802.11b client connections using link integrity maintain 802.11b client connections using link integrity
NOTE:
This feature is only applicable to 2.4 GHz (802.11b) cards.
[Device Name]>show linkinttbl
(this shows the current links)
[Device Name]>set linkinttbl <1-5
(depending on what row in the table you wish to address)>
ipaddr
[Device Name]>set linkintpollint
[Device Name]>set linkintpollretx
the link down>
[Device Name]>set linkintstatus enable
[Device Name]>reboot 0
disable vlan management disable vlan management disable vlan management disable vlan management
[Device Name]>set vlanmgmtid <1-4094, 0 = disable>
[Device Name]>set vlanstatus disable
[Device Name]>reboot 0