Configuring advanced features, In this chapter, Uring – HP ProCurve 520wl Wireless Access Point User Manual
Page 50: Fe re, Config, Ad nced atu, 4 configuring advanced featuress
4-1
4444
configuring advanced features
configuring advanced features
configuring advanced features
configuring advanced features
in this chapter
in this chapter
in this chapter
in this chapter
Some of the more complex networking configurations are described in this chapter:
Q
Advanced DHCP Server Configuration
Q
Q
Set parameters for DHCP server including the IP Pool table. Configure
Link Integrity settings and Target IP Address table.
Q
Q
VLAN Workgroups and Traffic Management
Q
Typical User VLAN Configurations
Q
Typical VLAN Management ID Configuration Scenarios
Setup a VLAN network.
Q
Q
Configuring Management Service Interfaces
Configure system management settings such as passwords,
management IP Access table, and services’ parameters (SNMP,
Telnet, HTTP, Serial).
Q
Setting the Ethernet Protocol Filter
Q
Q
Set WL520 device filters including Ethernet filters, Static MAC
address filters, and other advanced filters.
Q
Q
Q
Set alarms (SNMP Traps) including enabling alarm groups and the
alarm host table. Also, configure the Syslog settings.
Q
Q
Q
Broadcast Storms and Storm Thresholds
Q
Q
Setup the WL520 device as a simple bridge or a wireless repeater,
setup loop avoidance through the Spanning Tree protocol and Storm
Threshold protection. Also, allows you to filter packets based on MAC
addresses, prevent wireless clients associated with the same WL520
from communicating with each other, and forward all wireless traffic
to a specified network node.
Wireless Distribution System (WDS)
Q
Q
Q
Configuring the WL520 Unit as a Wireless Repeater
Establish point-to-point connections with other access points (the
wireless backbone).
Q
Fallback to Primary RADIUS Server
Q
Q
Configure RADIUS server settings to implement advanced features,
including RADIUS Accounting and DNS client functionality to support
RADIUS server host names.