HP ProCurve 520wl Wireless Access Point - Manual (Page 108)

Parameter Tables
6-25
NOTE:
The DHCP Server (dhcpstatus) can only be enabled after a DHCP IP Pool table entry has been created.
dhcp server table for ip pools dhcp server table for ip pools dhcp server table for ip pools dhcp server table for ip pools
NOTE:
Set either End IP Address or Width (but not both) when creating an IP address pool.
vlan parameters vlan parameters vlan parameters vlan parameters
vlan id table vlan id table vlan id table vlan id table
DHCP Server Group N/A R dhcp
DHCP Server Status Integer enable (1) (default)
disable (2)
delete (3)
RW dhcpstatus
Gateway IP Address IpAddress User Defined RW dhcpgw
Primary DNS IP Address IpAddress User Defined RW dhcppridnsipaddr
Secondary DNS IP Address IpAddress User Defined RW dhcpsecdnsipaddr
Number of IP Pool Table Entries Integer32 N/A R dhcpippooltblent
name name name name type type type type values values values values access access access access cli parameter cli parameter cli parameter cli parameter
DHCP Server IP Address Pool
Table
Table N/A R dhcpippooltbl
Table Index Integer User Defined N/A index
Start IP Address IpAddress User Defined RW startipaddr
End IP Address IpAddress User Defined RW endipaddr
Width Integer User Defined RW width
Default Lease Time (optional) Integer32 > 0
86400 sec (default)
RW defleasetm
Maximum Lease Time (optional) Integer32 > 0
86400 sec (default)
RW maxleasetm
Comment (optional) DisplayString User Defined RW cmt
Status (optional) Integer enable (1)
disable (2)
delete (3)
RW status
name name name name type type type type values values values values access access access access cli parameter cli parameter cli parameter cli parameter
VLAN Group N/A R vlan
Status Integer enable
disable (default)
RW vlanstatus
Management ID VlanId 0 (disable) or 1 – 4094 RW vlanmgmtid
name name name name type type type type values values values values access access access access cli parameter cli parameter cli parameter cli parameter
VLAN ID Table Table N/A R vlanidtbl
Index Integer32 1 (Wireless A)
2 (Wireless B)
R index
Identifier (ID) VlanId 0 (disable) or 1 – 4094 RW id