Configure mac access control, Configure mac access control -20 – HP ProCurve 520wl Wireless Access Point User Manual

Page 103

Other Network Settings

6-20

configure management ports

[Device Name]>set snmpifbitmask <0, 1, 4, 8, 15

(default is 15 see below)>

[Device Name]>set httpifbitmask <0, 1, 4, 8, 15

(default is 15 see below)>

[Device Name]>set telifbitmask <0, 1, 4, 8, 15

(default is 15 see below)>

Choose from the following values:

edit management ip access table

[Device Name]>set mgmtipaccesstbl ipaddr ipmask

configure serial port interface

NOTE:

To avoid unexpected WL520 performance, leave Flow Control value at default (none) unless you are sure what this

setting should be.

[Device Name]>set serbaudrate <2400, 4800, 9600, 19200, 38400, 57600>

[Device Name]>set serflowctrl

[Device Name]>show serial

Figure 6-14

Figure 6-14 Result of “show serial” CLI Command

Result of “show serial” CLI Command

configure mac access control

setup mac (address) access control table

[Device Name]>set macaclstatus enable

[Device Name]>set macacloptype

[Device Name]>reboot 0

add an entry to the mac access control table

[Device Name]>set macacltbl macaddr

status enable

[Device Name]>show macacltbl

disable or delete an entry in the mac access control table

[Device Name]>set macacltbl status

[Device Name]>show macacltbl

NOTE:

For larger networks that include multiple WL520 devices, you may prefer to maintain this list on a centralized location

using the RADIUS parameters (see

Set RADIUS Parameters

interface bitmask

description

0 = disable (all interfaces)

All management channels disabled

1 = ethernet if

Ethernet only enabled

4 = pcCardA if

Wireless A only enabled

8 = pcCardB if

Wireless B only enabled

15 = allInterfaces

All management channels enabled