Tcp/udp port filtering, Syslog parameters, Tcp/udp port filtering -35 – HP ProCurve 520wl Wireless Access Point User Manual
Page 118: Syslog parameters -35, Parameter tables 6-35
Parameter Tables
6-35
tcp/udp port filtering
tcp/udp port filtering
tcp/udp port filtering
tcp/udp port filtering
The following parameters are used to enable/disable the Port filter feature.
The following parameters are used to configure TCP/UDP Port filters.
syslog parameters
syslog parameters
syslog parameters
syslog parameters
The following parameters configure the Syslog settings.
NOTE:
The Heartbeat parameters are advanced settings not available via the HTTP interface. When Heartbeat is enabled,
the WL520 periodically sends a message to the Syslog server to indicate that it is active. The frequency with which the
heartbeat message is sent depends upon the setting of the Heartbeat Interval.
name
name
name
name
type
type
type
type
values
values
values
values
access
access
access
access
cli
cli
cli
cli
Port Filtering
Group
N/A
R
portflt
Port Filter Status
Integer
enable (default)
disable
RW
portfltstatus
name
name
name
name
type
type
type
type
values
values
values
values
access
access
access
access
cli
cli
cli
cli
Port Filtering Table
Table
N/A
R
portflttbl
Table Index
N/A
User Defined
(there are also 4 pre-defined
indices, see “
”
below for more information)
R
index
Port Type
Octet String
TCP
UDP
TCP/UDP
RW
porttype
Port Number
Octet String
User Defined
(there are also 4 pre-defined
protocols:
NetBios Name Service – 137,
NetBios Datagram Service –
138, NetBios Session Service
– 139, SNMP Service – 161)
RW
portnum
Protocol Name
DisplayString
User Defined
(there are also 4 pre-defined
protocols, see ”
” above)
RW
protoname
Interface Bitmask
Integer32
1 (Ethernet only)
4 (Slot A only)
5 (Slot A & Ether)
8 (Slot B only)
9 (Slot B & Ether)
12 (Slot A & B)
15 (All interfaces)
RW
ifbitmask
Status
Integer
enable (1)
disable (2)
delete (3)
RW
status
name
name
name
name
type
type
type
type
values
values
values
values
access
access
access
access
cli
cli
cli
cli
Syslog
Group
N/A
R
syslog
Syslog Status
Integer
enable
disable (default)
RW
syslogstatus
Syslog Port
Octet String
514
R
syslogport
Syslog Lowest Priority Logged
Integer
1 – 7
1 = LOG_ALERT
2 = LOG_CRIT
3 = LOG_ERR
4 = LOG_WARNING
5 = LOG_NOTICE
6 = LOG_INFO (default)
7 = LOG_DEBUG
RW
syslogpritolog
Heartbeat Status
Integer
enable (1)
disable (2) (default)
RW
heartbeatstatus
Heartbeat Interval (seconds)
Integer
1 – 604800 seconds;
900 sec. (default)
RW
heartbeatinterval