HP ProCurve 520wl Wireless Access Point - Manual (Page 49)

Issuing System Commands
3-11
reset reset reset reset
Figure 3-16 Figure 3-16 Figure 3-16 Figure 3-16 Command Screens - Reset Command Screens - Reset Command Screens - Reset Command Screens - Reset
Use the Reset Reset Reset Reset tab to restore the WL520 to factory default conditions. The WL520 may also be reset from the RESET RESET RESET RESET button on
indicator side of the unit. Since this will reset the current WL520 IP Address, a new IP Address must be assigned. Also refer to
Recovery Procedures .
help link help link help link help link
Figure 3-17 Figure 3-17 Figure 3-17 Figure 3-17 Command Screens - Help Link Command Screens - Help Link Command Screens - Help Link Command Screens - Help Link
To open Help Help Help Help , click the Help Help Help Help button on any display screen.
During initialization, the WL520 on-line help files are downloaded to the default location:
C:\Program Files\WL520_AP\AP\Help\.
If you want to place these files on a shared drive, copy the Help Folder to the new location, and then specify the new path in
the Help Link box.