HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 284)

Appendix B: Auto-deployment process 284
Property Description
TFTP Server The TFTP Server property displays the TFTP server used for the deployment operation. If
the TFTP Mode is "AUTO", then the value is populated with the server provided by
DHCP. If the TFTP Mode is "MANUAL", the value of the property is expected to be
provided by the user with the VCMCLI set autodeployment command, and can
also be configured in the GUI. This field allows an IPv4 or IPv6 address as well as a
DNS name.
TFTP File The TFTP File property displays the VCMCLI configuration file used for the deployment
operation that exists on the TFTP server. If the TFTP Mode is "AUTO", then the value will
be populated with the server provided by DHCP. If the TFTP Mode is "MANUAL", the
value of the property is expected to be provided by the user with the VCMCLI set
autodeployment command, and can also be configured in the GUI.
In a successful deployment, the status is shown as "Completed". If the deployment process encountered a
failure, the status indicates why the deployment process was not successful. Additional details about the
failure can be found in the deployment log and can be used for initial troubleshooting.
The deployment status
To view only the status of the deployment, use the show auto-deployment status command as shown
below:
->show auto-deployment status
Completed
During the deployment process, you might see several values show up during the deployment. If a failure
occurs during the deployment process, a failure status is shown for the deployment status.
The potential status values you might see during and after deployment operations are shown in the table in
the section "Normal deployment status values (on page 284 )."
Normal deployment status values
Status Comment
Not Deployed A deployment has not yet been attempted.
In Progress The deployment operation was recently started and is currently in progress.
Powering Off Servers The physical servers in the enclosure are being powered off. The deployment process
usually requires servers to be powered off because of server profile assignment, and other
server related commands that could occur during deployment.
Clearing Domain
Configuration The domain is currently being cleared. During deployment operations, if a domain is
currently configured, it must be cleared before it can be reconfigured as a part of the
redeployment process.
Domain
Configuration
Cleared
The domain configuration has been cleared successfully.
Configuring Domain The VC domain configuration is being configured. This process can take a few seconds or
several minutes, depending on the size of the configuration being deployed.
Completed The deployment completed successfully.