Vc configuration file, Importing the enclosure into the domain – HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem User Manual
Page 281
Appendix B: Auto-deployment process 281
>cp myconfig-2.script /tftpboot
VC configuration file
The following sample configuration script can be used for basic deployment testing of the DHCP and TFTP
setup. After deployment, the domain configuration can be validated through the GUI or VCMCLI.
Example
myconfig.script
#============================================
# myconfig.script
#
# A simple VCMCLI configuration script used
# for Auto-Deployment testing
#
# Version 2012.0728.1
#============================================
# Add Networks
add network Network1
add network Network2
# Add Shared Uplink Sets
add uplinkset UplinkSet1
add uplinkset UplinkSet2
# Add Profiles
add profile Profile1
add profile Profile2
# Add Users
add user Admin password=Admin123 privileges=*
# Assign Profiles to Servers
assign profile Profile1 enc0:1
assign profile Profile2 enc0:2
# Power Servers On
poweron server *
Importing the enclosure into the domain
After an enclosure is imported into a domain using 4.10 or higher firmware, the configuration is enabled for
auto-deployment use by default. No deployment operation is attempted until the start
auto-deployment command is issued by the user, as described in "Auto-deployment settings after
)."
--------------------------------------------------------------------
HP Virtual Connect Management CLI v4.10
Build: 4.10
(C) Copyright 2006-2013 Hewlett-Packard Development Company, L.P.
All Rights Reserved
---------------------------------------------------------------------