HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 25)

Virtual Connect domains 25
Task Action
View the configuration file Click View next to Configuration File.
View the deployment log Click View next to Deployment Log.
View the CLI output Click View next to CLI Output.
For more information on auto-deployment, see "Appendix B: Auto-deployment process (on page 278 )."
Domain Settings (IP Address) screen
Beginning with VC 4.10, VCM supports the use of IPv6 addresses. IPv6 introduces a 128-bit address that
provides better security, simplicity in configuration, and improved maintenance. To migrate from IPv4 to
IPv6, the network must have an infrastructure that can support and implement the IPv6 protocol.
Use this screen to set a domain IPv4 or IPv6 address for the Virtual Connect domain. This IP address is then
consistent, regardless of which module is primary within the domain.
The optional domain IP address setting allows for a consistent IP address that is independent of the
interconnect module on which it is running. If set, this IP address must be unique within the network and must
be different than the IP address of the module itself. If this IP address is not set, the VC Manager can still be
reached through the IP address of the host VC-Enet module.
To use an optional domain IP address, select the Use Domain IP address check box, and then enter the IP
Address, Subnet Mask, and Default Gateway.
NOTE: Even if a domain IP address is provided, the normal IP address assigned to the
interconnect bay can still be used.
The following table describes the available actions in the Domain Settings (IP Address) screen. Clicking
another link in the pull-down menu or left navigation tree causes current edits that have not been applied to
be lost.