beautypg.com

HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem User Manual

Page 108

background image

Virtual Connect networks 108

Item

Description

Share

Minimum guaranteed bandwidth that each traffic class gets. The sum of shares of all

enabled classes and the Best_Effort class equals 100.

Max Share

Maximum share that the traffic class can use when other traffic classes are not using

their maximum share.

Egress DOT1P Priority The egress dot1p priority marking on the VLAN tag.
Enabled

The FCoE Lossless and Best_Effort classes are enabled by default. Other classes are

enabled if the checkbox in the Enabled column is selected.

Reset QoS
configuration to default

values

Click Reset, and then click Apply.

IMPORTANT: Clicking Reset, and then clicking Apply resets the values on both the
Traffic Class and Ingress Traffic Classification tabs to the default values for active and

inactive configurations.

The following table lists the available actions from this screen:

Action

Description

Edit the name of a traffic class

Click on the name of the traffic class, edit the name, and then

click Apply.

Designate a traffic class as real time

Select the checkbox in the Real Time column of the class. If a
class is already designated as Real Time, unselect that

checkbox, and then select the checkbox in the Real Time column

of the new class. If necessary, adjust the numbers in the Share
and Max Share columns. These numbers must be equal, and

cannot be more than 50.

Edit the Share for a traffic class

Click on the number in the Share column, and then type in a new
number. Click Apply.

Edit the Max Share for a traffic class

Click on the number in the Max Share column, and then type in

a new number. Click Apply.

Edit the egress DOT1P priority for a traffic
class

Click on the number in the Max Share column, and then select a

new number from the pull-down list. The same egress DOT1P
priority value cannot be used for more than on enabled traffic

class.

Enable or disable a traffic class

Select or deselect the checkbox in the Enabled column of the
traffic class to be enabled or disabled. System classes cannot be

disabled.