HP Photosmart C6340 All-in-One Printer - Manual (Page 45)

Use the Embedded Web Server to modify network settings
The Embedded Web Server gives you an intuitive interface to your network connection
parameters.
To access the Embedded Web Server setup wizard
1. Print a network configuration page to find the IP address for the product.
2. In the Address box in your Web browser on your computer, type the IP address of
the product, as shown on the network settings page. For example, http://
192.168.1.101.
The Embedded Web Server Home page appears, showing information for the
product.
NOTE: If you are using a proxy server in your browser, you might need to disable
it to access the Embedded Web Server.
3. Click the Networking tab.
4. Click Wired (802.3) or Wireless (802.11) in the Connections navigation menu.
5. Click Start Wizard, and then follow all of the wizard instructions.
Related topics
“View and print network settings” on page 37
Network configuration page definitions
The network configuration page shows the network settings for the product. There are
settings for general information, 802.3 wired (Ethernet), and 802.11 wireless.
This section contains the following topics:
• General network settings
• Wired (802.3) network settings
• Wireless (802.11) network settings
Related topics
• “View and print network settings” on page 37
• “Network glossary” on page 48
Chapter 4
42 Finish setting up the HP All-in-One
Finish set
up