HP Photosmart C6340 All-in-One Printer - Manual (Page 29)

connector) is wider and thicker and always has 8 contacts on the end. A phone
connector has between 2 and 6 contacts.
❑ A desktop computer or laptop with an Ethernet connection.
NOTE: The HP All-in-One supports both 10 Mbps and 100 Mbps Ethernet
networks. If you are purchasing, or have purchased, a network interface card
(NIC), make sure it can operate at either speed.
Connect the HP All-in-One to the network
To connect the HP All-in-One to the network, use the Ethernet port on the back of the
product.
To connect the product to the network
1. Remove the yellow plug from the back of the product.
2. Connect the Ethernet cable to the Ethernet port on the back of the product.
3. Connect the other end of the Ethernet cable to an available port on your Ethernet
router or switch.
4. Once you have connected the product to the network, install the software.
Related topics
“Install the software for a network connection” on page 34
Chapter 4
26 Finish setting up the HP All-in-One
Finish set
up