HP Photosmart C6340 All-in-One Printer - Manual (Page 198)

Scan fails
Try the following solutions to resolve the issue. Solutions are listed in order, with the most
likely solution first. If the first solution does not solve the problem, continue trying the
remaining solutions until the issue is resolved.
• Solution 1: Turn on your computer
• Solution 2: Check the connection from the product to your computer
• Solution 3: Install the HP Photosmart Software
• Solution 4: Start the HP Photosmart Software
Solution 1: Turn on your computer
Solution: Turn on your computer.
Cause: The computer was not turned on.
If this did not solve the issue, try the next solution.
Solution 2: Check the connection from the product to your computer
Solution: Check the connection from the product to your computer. Verify that the
USB cable is securely plugged into the USB port on the back of the product. Make
sure the other end of the USB cable is plugged into a USB port on your computer.
After the cable is connected properly, turn off the product and then on again.If the
product is connected to the computer through a wired or wireless connection make
sure that the respective connections are active and the product is turned on.
For more information, see the Start Here guide.
Cause: The product was not properly connected to the computer.
If this did not solve the issue, try the next solution.
Solution 3: Install the HP Photosmart Software
Solution: Insert the HP Photosmart installation CD and install the software.
For more information, see the Start Here guide.
Cause: The HP Photosmart Software might not have been installed.
If this did not solve the issue, try the next solution.
Solution 4: Start the HP Photosmart Software
Solution: Start the software you installed with the product and try scanning again.
Cause: The HP Photosmart Software was installed, but was not running.
Scan troubleshooting 195
Trou
bles
ho
ot
ing