HP Photosmart C6340 All-in-One Printer User Manual
Page 30

Set up the HP All-in-One on an integrated wireless (WLAN 802.11) network
The HP All-in-One uses an internal networking component that supports a wireless
network.
For optimal performance and security in your wireless network, HP recommends you use
a wireless router or access point (802.11) to connect the product and the other network
elements. When network elements are connected through a wireless router or access
point, this is called an infrastructure network.
The advantages of a wireless infrastructure network as compared to an ad hoc network
include:
•
Advanced network security
•
Enhanced reliability
•
Network flexibility
•
Better performance
•
Shared Broadband Internet access
To set up the HP All-in-One on an integrated
wireless WLAN 802.11 network, you need to
do the following:
See this section:
First, collect all of the required materials.
“What you need for an integrated wireless
WLAN 802.11 network” on page 27
Next, connect the HP All-in-One to the wireless
router, and run the Wireless Setup Wizard.
“Connect to an integrated wireless WLAN
802.11 network” on page 28
Finally, install the software.
“Install the software for a network connection”
on page 34
What you need for an integrated wireless WLAN 802.11 network
To connect the HP All-in-One to an integrated wireless WLAN 802.11 network, you will
need the following:
❑ A wireless 802.11 network that includes a wireless router or access point
(recommended).
❑ A desktop computer or laptop with either wireless networking support, or a network
interface card (NIC). The computer must be connected to the wireless network that
you intend to install the HP All-in-One on.
Connect to a computer
27
Finish
set
up