NORD Drivesystems BU0060 - Manual (Page 34)

CANopen – Supplementary manual options for NORD - Frequency Inverters
34 BU 0060 GB-4112
NOTICE
Entry of moisture
During installation, attention must be paid to proper sealing (do not forget the rubber seal!), to prevent the entry
of moisture.
With IP66 versions, care must also be taken that the cables and cable glands at least comply with protection
class IP66, so that compliance with protection class IP66 is ensured on the frequency inverter.
Pos : 52 /Anl eitungen/ Elektroni k/ Bus s yst eme/2. Baugruppen/Stec ker- und Z ubehör- Komponent en/! Empfohlene Stec ker- und Zubehör- Komponent en @ 1\ mod_1335448576891_388. doc x @ 23681 @ 3 @ 1
2.3.4 Recommended connector and accessory components
Note Recommendations of products
The components listed below or in this section should only be regarded as recommendations. For further
information please refer to the particular manufacturer's information and data sheets.
Please observe the manufacturer's information regarding installation and the corresponding installation
guidelines.
Pos : 53 /Anl eitungen/ Elektroni k/ Bus s yst eme/2. Baugruppen/Stec ker- und Z ubehör- Komponent en/M12 R unds tec kver binder CAN [C AN] @ 1\ mod_1342001545219_388.doc x @ 31482 @ 56666 @ 1
M12 round plug CAN connector
Information Connection components
For preference, pre-assembled CAN bus cables and connection components should be used.
For certain applications, vibration-proof round plug connectors should be used.
M12 connector
A coded
Supplier Name Part no.:
straight angled
MURR Elektronik M12 plug, 6...8mm, 5-pin,
screwed, IP67, shielded 7000-13321-0000000 7000-13361-0000000
Franz Binder GmbH M12 plug, 6...8mm, 5-pin,
screwed, IP67, 99 1437 812 05 99 1437 822 05