NORD Drivesystems BU0060 - Manual (Page 28)

CANopen – Supplementary manual options for NORD - Frequency Inverters
28 BU 0060 GB-4112
2.2.7 Installation of the SK CU1-xxx customer unit
WARNING electric shock
Modules must not be inserted or removed unless the device is free of voltage. The slots may only be used for
the intended modules. Installation remote from the frequency inverter is not possible. It must be connected
directly to the frequency inverter.
Failure to comply with this may result in an electric shock, which my cause serious injury and the destruction of
the frequency inverter and the module.
Note Error message E017
Following the insertion, replacement or removal of modules, and once the equipment has been switched on
again, this procedure is indicated with the message E017 Customer unit changed.
This message can be directly reset by the usual measures.
Installing the customer unit
1. Switch off the mains voltage, observe
the waiting period.
2. Remove the cover grille from the
connection area by loosening the 2
screws and levering out the device
cover (slot) or simply pull it out.
3. Locking lever in the "„open“ position.
4. Using light pressure push the
customer unit into the upper guide rail
until it engages.
5. Locking lever in the „closed“ position.
6. Remove the connector by pressing the
releases then make the necessary
connections. Then insert the
connectors until they engage.
7. Replace all covers.
Kundenschnittstelle
Sondererweiterung
Technologiebox
Verrieglungsstift
CLOSED
OPEN
Verriegelung geschlossen
Verriegelung geöffnet
Customer
interface
Special
extension
Technology unit Locking lever
Lock closed
Lock open