KROHNE OPTIMASS with MFC 05x EN - Manual (Page 84)

Installation and Operating Instructions OPTIMASS 83
Volume Total Fct. 3.2.5.
Parameters for the volume totalizer are selected in this menu.
Display Key
Line 1 Line 2
From Fct. 3.2.5 Volume Tot.
→ (off) – default is off.
↑ Selects the totalizer display.
00000.000 (cm³)
↑ Selects the units. Selection of cm³, dm³, litre, m³, in³, ft³, US gal,
Impgal, off.
→ Allows the position of the decimal place to be changed.
When selection complete press ↵.
Temperature Fct. 3.2.6.
Selects the temperature units.
Display Key
Line 1 Line 2
From Fct. 3.2.6 Temperature.
→ ºC.
↑ Selects units. Choose from ºC, ºF.
↵ After selection
Density Fct. 3.2.7
Allows the selection of density units and measurement resolution.
Display Key
Line 1 Line 2
From Fct. 3.2.7 Density.
→ 00000.000 (kg)/m³.
↑ Allows the selection of the units. Choose from kg, t, oz, Ib, SG, g.
→ Selects the volume units to be changed. Choose from m³, in³,
ft³,US gal, Impgal, cm³, dm³, litre.
→ The decimal position can now be selected using the ↑ key.
When selection complete press ↵.
Concentration Flow Fct. 3.2.8.
The concentration option has to be activated to access this menu. When this option has not been ordered
the words “Not Fitted” will appear in the display.
If this option was ordered, please refer to separate manual supplied with this option.
Concentration Total Fct. 3.2.9.
As per Fct. 3.2.8
The concentration total will be indicated by the letter “C” in the left corner of the display.
Concentration by mass Fct. 3.2.10.
As per Fct 3.2.8.
Concentration by Volume Fct. 3.2.11
As per Fct. 3.2.8.