KROHNE OPTIMASS with MFC 05x EN User Manual
Page 56
Installation and Operating Instructions OPTIMASS
55
4.3.1 How to enter programming mode
To start:
Display Comments
→ Press
Fct. 1
OPERATION
or
If this appears, see box: ”Function of the keys ” in 4.3.
CodE 1
---------
If this appears on the display, set the 9-keystroke Supervisor CodE
1 .
Factory setting:
→ → → ↵ ↵ ↵ ↑ ↑ ↑
1
st
- 8
th
place
(key)
CodE 1
∗∗∗∗∗∗∗∗-
Each keystroke acknowledged by " * " in display.
9
th
place
(key)
Fct. 1
OPERATION
If this appears, see box: ”Function of the keys ” in 4.3.
XXXXX
CODE WRONG
A wrong Supervisor CodE 1 was keyed in. Press any key and set
the correct 9-keystroke Supervisor CodE 1.*
* If correct code is not known, note number given (XXXXX) and contact KROHNE for further instructions
regarding decoding.
4.3.2 How to terminate Programming mode
To terminate:
Display Comments
Press
↵ 1-5
times
Fct (1).0
OPERATION
Press
↵ 1...5 times until the cursor is under the extreme left menu
column. (Fct. 1, 2, 3, 4 or 5).
↵
+ 12.3
kg/min
or
If no changes have been made to the system’s configuration return
directly to the measurement mode.
(ACCEPT
YES)
Changes have been detected. Press
↵ to accept these changes.
or
↑
(ACCEPT NO)
Press
↵ to reject changes and return directly to measurement
mode.
or
↑
(GO BACK)
Press
↵ to return to the menus, Fct. 1.(0) to make further changes
Return to measurement mode.