KROHNE OPTISONIC 3400 EN - Manual (Page 89)

OPERATION
6
89
OPTISONIC 3400
www.krohne.com 11/2013 - 4002037702 - HB OPTISONIC 3400 -en-R02
I S Electr: Power
Failure
Tot 1 Power Failure Power failure has occurred.
The totaliser state may be
invalid.
Check the value of the
totaliser.
Tot 2 Power Failure
Tot 3 Power Failure
Power Failure Detected
I I Electr.
Operation Info.
Zero Calibr. Running A zero calibration in
progress.
Wait until finished
Sensor Starting up. Sensor starts up. This is
normal operation at the
beginning of measuring
mode. Other error
messages are suppressed
After some moments, the
converter will act and
respond with the converter
status.
PROFIBUS: no data No data exchange via
PROFIBUS.
Tot 1 Stopped Totaliser 1 was stopped. If totaliser is to continue
counting, select "Yes" in
Fct. C.y.9 (Start Totaliser).
Tot 2 Stopped Totaliser 2 was stopped.
Tot 3 Stopped Totaliser 3 was stopped.
Control In A Active
Control In B Active
Status Out A Active
Status Out B Active
Status Out C Active
Status Out D Active
Disp. 1 Overrange The value in the 1st
measurement line of the
display page is limited.
Check setting for 1st
measurement line.
Disp. 2 Overrange The value in the 2nd
measurement line of the
display page is limited.
Check setting for 2nd
measurement line.
Optical Interf. Active The optical interface is being
used. The optical keys are
deactivated.
The keys are ready for
operation again approx. 60
seconds after the end of the
data transfer/removal of the
optical interface.