KROHNE OPTISONIC 3400 EN - Manual (Page 64)

6
OPERATION
64
OPTISONIC 3400
www.krohne.com 11/2013 - 4002037702 - HB OPTISONIC 3400 -en-R02
A4 Station Address
A4 Station Address For Profibus / FF / Modbus devices.
A5 Digital Outputs
A5 Digital Outputs Valid for all pulse outputs (terminals A, B and/or D) and totaliser 1.
A5.1 Measurement 1) Select measurement: Volume Flow / Mass Flow
2) Use for all outputs? (also use this setting for Fct. A5.2...A5.5!)
Setting: No (only for pulse output D) / Yes (for all digital outputs)
A5.2 Pulse Value Unit Selection of the unit from a list, depending on the measurement.
A5.3 Value p. Pulse 1) Setting for pulse output D (volume or mass value per pulse)
Setting: xxx.xxx in l/s or kg/s
2) Use for all outputs? Make setting, see Fct. A5.1 above!
A5.4 Low Flow Cutoff 1) Setting for pulse output D (sets output value to "0")
Setting: x.xxx ± x.xxx% (range: 0.0…20%)
(1st value = switching point / 2nd value = hysteresis),
condition: 2nd value ≤ 1st value
2) Use for all outputs? Make setting, see Fct. A5.1 above!
A6 GDC IR interface
A6 GDC IR Interface After this function has been activated an optical GDC adapter can be
connected to the LC display. After 60 seconds pass without a connection
being established or after the adapter is removed, the function is exited and
the optical keys are active again.
Break (exit function without connection)
Activate (the IR interface adapter and interrupt the optical keys)
No. Function Setting / Description