KROHNE OPTISONIC 3400 EN - Manual (Page 57)

OPERATION
6
57
OPTISONIC 3400
www.krohne.com 11/2013 - 4002037702 - HB OPTISONIC 3400 -en-R02
6.1.1 Display in measuring mode with 2 or 3 measured values
Key Measuring mode Menu mode Submenu or function
mode Parameter and data
mode
> Switch from measuring
mode to menu mode;
press key for 2.5 s,
"Quick Start" menu is
then displayed
Access to displayed
menu, then 1st
submenu is displayed
Access to displayed
submenu or function
For numerical values,
move cursor
(highlighted in blue) one
position to the right
^ Reset display; "Quick
Access" function
Return to measuring
mode but prompt
whether the data should
be saved
Press 1 to 3 times,
return to menu mode,
data saved
Return to submenu or
function, data saved
↓ or ↑ Switch between display
pages: measured
value 1 + 2, trend page
and status page
Select menu Select submenu or
function
Use cursor highlighted
in blue to change
number, unit, property
and to move the decimal
point
Esc (> + ↑) - - Return to menu mode
without acceptance of
data
Return to submenu or
function without
acceptance of data
Figure 6-2: Example for display in measuring mode with 2 or 3 measured values
1 Indicates a possible status message in the status list
2 Tag number (is only indicated if this number was entered previously by the operator)
3 1st measured variable in large representation
4 Bargraph indication
5 Depiction with 3 measured values