KROHNE OPTISONIC 3400 EN - Manual (Page 70)

6
OPERATION
70
OPTISONIC 3400
www.krohne.com 11/2013 - 4002037702 - HB OPTISONIC 3400 -en-R02
C2._.10 Invert Signal Select:
Off (activated output: switch closed) /
On (activated output: switch open)
C2._.11 Phase Shift w.r.t. B Only available when configuring the A or D terminal and only if output B is a
pulse or frequency output. If setting in Fct. C2.2.7 is "Both Polarities", the
phase shift is prefixed by a symbol, e.g. -90° and +90°
Select:
Off (no phase shift) /
0° Phase Shift (between outputs A or D and B, inversion possible) /
90° Phase Shift (between outputs A or D and B, inversion possible) /
180° Phase Shift (between outputs A or D and B, inversion possible)
C2.3.11 Special Functions This function is only available at the pulse output of terminal B. At the same
time, 2 pulse outputs must be available:
1st output at terminal A or D / 2nd output at terminal B
The B output is operated as a slave output, controlled and set using master
output A or D
Select:
Off (no phase shift) /
Phase Shift w.r.t. D or A (slave output is B and master output is D or A)
C2._.12 Information Serial no. of the I/O board, software version no. and production date of the
circuit board
C2._.13 Simulation Sequence see B1._ Pulse Output X
C2._ Status Output X
C2._ Status Output X X (Y) stands for one of the connection terminals A, B, C or D
C2._.1 Mode The output shows the following measuring conditions:
Out Of Specification (output set, signals status of category "Error in Device"
or "Application Failure" or "Out Of refer to Status messages and diagnostic
information on page 83 )/
Application Failure (output set, signals status of category "Error in Device"
or "Application Failure" refer to Status messages and diagnostic
information on page 83) /
Flow Polarity (polarity of the current flow)
Flow Over Range (over range of the flow)
Totaliser 1 Preset (activates when totaliser X preset value is reached) /
Totaliser 2 Preset (activates when totaliser X preset value is reached) /
Totaliser 3 Preset (activates when totaliser X preset value is reached) /
Output A (activated by the status of output Y, additional output data see
below) /
Output B (activated by the status of output Y, additional output data see
below) /
Output C (activated by the status of output Y, additional output data see
below) /
Output D (activated by the status of output Y, additional output data see
below) /
Off (switched off) /
Empty Pipe (when pipe empty, output activated) /
Error in Device (output set, signals status of category "Error in Device" refer
to Status messages and diagnostic information on page 83)
C2._.2 Current Output Y Only appears if output A...C is set under "Mode" (see above), and this output
is a "Current Output".
Polarity (is signalled)
Over Range (is signalled)
Automatic Range signals lower range
C2._.2 Frequency Output Y and
Pulse Output Y
Only appears if output A, B or D is set under "Mode" (see above), and this
output is a "Frequency/Pulse Output".
Polarity (is signalled)
Over Range (is signalled)
No. Function Settings / descriptions