KROHNE OPTISONIC 3400 EN - Manual (Page 73)

OPERATION
6
73
OPTISONIC 3400
www.krohne.com 11/2013 - 4002037702 - HB OPTISONIC 3400 -en-R02
C3._.7 Set Totaliser Set Totaliser _ to the desired value
Select:
Break (exit function) / Set Value (opens the editor to make the entry)
Query: Set Totaliser?
Select:
Select: No (exit function without setting the value) / Yes (sets the totaliser
and exits the function)
C3._.8 Stop Totaliser Totaliser _ stops and holds the current value.
Select:
No (exits the function without stopping the totaliser) / Yes (stops the totaliser
and exits the function)
C3._.9 Start Totaliser Start Totaliser _ after that totaliser is stopped
Select:
No (exits the function without starting the totaliser) / Yes (starts the totaliser
and exits the function)
C3._.10 Information Serial no. of the I/O board, software version no. and production date of the
circuit board
No. Function Settings / descriptions
C4 I/O HART
C4 I/O HART Selection or display of the 4 dynamic variables (DV) for HART ®
The HART ® current output (terminal A basic I/Os or terminal C modular I/Os)
always has a fixed link to the primary variables (PV). Fixed links of the other
DVs (1-3) are only possible if additional analogue outputs (current and
frequency output) are available; if not, the measurement can be freely
selected from the following list: in Fct. A4.1 "Measurement"
_ stands for 1, 2, 3 or 4
X stands for connection terminals A...D
C4.1 PV is Current output (primary variable)
C4.2 SV is (secondary variable)
C4.3 TV is (tertiary variable)
C4.4 4V is (4th variable)
C4.5 HART Units Changes units of DVs (dynamic variables) in the display
Break: return with ^ key
HART ® display: copies the settings for the display units to the settings for
DVs
Standard: factory settings for DVs
C4._.1 Current Output X Shows the current analog measured value of the linked current output. The
measurement cannot be changed!
C4._.1 Frequency Output X Shows the current analog measured value of the linked frequency output, if
present. The measurement cannot be changed!
C4._.1 HART Dynamic Var.
Measurements of the dynamic variables for HART ® .
Select:
Volume Flow / Mass Flow / Diagnosis / Velocity /
Totaliser 1 / Totaliser 2 / Totaliser 3 / Operating Hours
No. Function Settings / descriptions