Jenway 6715 - Manual (Page 117)

99
Factor
This is the value by which the rate of change is multiplied to give the concentration. Select the Factor
key and enter the factor value. Values from 0.01 to 9999 can be entered. If a Factor is not to be used
this value should be set to 1.00.
Selecting resolution
This enables the resolution of the result to be set. Resolution can be set using the Resolution key and
scrolling though the available options.
Resolution options are: 1, 0.1, 0.01 and 0.001.
Selecting Units
Selection of units is made using the Units key to scroll through the available measurement options.
The following units are available:- mEq/l, ppm, mg/l, g/l, %, µg/ml, mg/ml, g/dl, mg/dl, µg/l, ng/l, µg/dl,
M, mM, µM/l, U/l, mU/l, U/ml, blank.
note: The unit is simply a name tag added to the result. Due to the variety of samples that may be
measured it is impossible to enable any direct conversion between units.