Jenway 6715 - Manual (Page 115)

97
Setting lag time
Selecting the Lag Time key displays a numeric keypad. Clear the current setting and enter the
required lag time in seconds. The lag time is a portion of the run time over which no data is collected,
starting from the beginning of the run time. This allows for any latency or non-linear reaction to be
disregarded. Setting this to zero means data will be collected over the full run time. The limits for this
setting are from 0 to 9999 seconds.
Setting Start on level
Selecting the Start On Level key disables the lag time option. Repeated presses of this key cycle
through the Greater Than, Less Than and Disabled options. With Greater Than or Less Than
selected data collection will start when the measured value (Absorbance or Transmittance) is above or
below the value entered in the
Start Level setting.
Setting Start level
Selecting the Start Level key displays a numeric keypad. Clear the current setting and enter the
required level above or below which data collection is required.
Limits for this setting are – 0.299 to 2.999Abs and 0.1 to 199.1%T.