Brocade Web Tools Administrators Guide (Supporting Fabric OS v7.3.0) - Manual (Page 58)

NOTE
To remove a configuration, select a row in the table and click Delete.
8. Click Apply to save the values currently shown in the table or click Cancel to close the dialog box
without saving any of your changes.
9. To update the switch with your changes, update the table using the Add and Delete buttons, and
then click Apply.
Viewing IP addresses
If you want to view the IP addresses configured on the switch for the currently populated slots, use the
Show IP Address button.
Use this procedure to display the IP addresses.
1. Open the Switch Administration window as described in Opening the Switch Administration
window on page 52.
2. Select the Blade tab.
3. Click Show IP Address.
4. Scroll through the list to view all the information.
5. When you are finished, click Close.
Switch configuration
Use the Switch tab of the Switch Administration window to perform basic switch configuration.
Figure 7 on page 52 displays an example of the Switch tab.
Enabling and disabling a switch
You can identify whether a switch is enabled or disabled in the Switch Administration window by
looking at the lower-right corner. If you pause the pointer over the icon, the system displays text that
indicates the status of the switch.
Use this procedure to enable or disable a switch.
1. Open the Switch Administration window as described in Opening the Switch Administration
window on page 52.
2. Select the Switch tab.
3. In the Switch Status section, click Enable to enable the switch or Disable to disable the switch.
4. Click Apply.
The system displays a confirmation window that asks if you want to save the changes to the switch.
You must click Yes to save the changes.
Enabling and disabling switch persistent
Use this procedure to enable or disable switch persistent. By default, switch persistent is disabled.
Viewing IP addresses
58 Web Tools Administrator's Guide
53-1003169-01