Brocade Web Tools Administrators Guide (Supporting Fabric OS v7.3.0) - Manual (Page 235)

Administering FICON CUP Fabrics
● FICON CUP fabrics overview........................................................................................235
● Enabling port-based routing.......................................................................................... 236
● Enabling or disabling FICON Management Server mode............................................. 237
● FMS parameter configuration........................................................................................237
● Displaying code page information................................................................................. 239
● Viewing the control device state....................................................................................239
● Allow / Prohibit Matrix configuration.............................................................................. 240
● CUP logical path configuration......................................................................................243
● Link Incident Registered Recipient configuration.......................................................... 244
● Displaying Request Node Identification Data ...............................................................245
FICON CUP fabrics overview
Control Unit Port (CUP) is a protocol for managing FICON directors. Host-based management
programs manage the switches using CUP protocol by sending commands to the emulated control
device implemented by Fabric OS. A Brocade switch or director that supports CUP can be controlled by
one or more host-based management programs or director consoles, such as Brocade Web Tools or
Brocade Network Advisor. (Refer to the Brocade Network Advisor SAN User Manual for more
information about the Brocade Network Advisor.) The director allows control to be shared between host-
based management programs and director consoles.
NOTE
To perform FICON CUP operations, the EGM license must be enabled on the switches using the CUP
protocol. Also, the EGM license must be enabled to set the Allow/Prohibit Matrix parameters.
The EGM license is required only for 8 Gbps platforms, such as the following:
• Brocade Encryption Switch
• Brocade 300, 5300, 5100 and 5432 switches
• Brocade VA-40FC
• Brocade 7800
For non-8 Gbps platforms, all functionalities are available without EGM license.
NOTE
While enabling FMS mode with online devices connected to ports with addresses of 0xFE or 0xFF, the
following error message displays: FMS mode enable failed due to port(s) with areas
0xFE or 0xFF is (are) connected to device(s). You must disable the ports or remove the
online devices from those ports that are mapped to the 0xFE or 0xFF address.
To use FICON CUP, you must do the following:
• Install a FICON CUP license on a FICON director.
• Enable FICON Management Server (FMS) mode on the FICON director.
Web Tools Administrator's Guide 235
53-1003169-01