Brocade Web Tools Administrators Guide (Supporting Fabric OS v7.3.0) - Manual (Page 243)

4. Optional : Click Active=Saved Mode to enable (selected) or disable (not selected) the
Active=Saved FMS parameter after the configuration is activated.
5. Click Yes to activate the configuration or click No to cancel the activation.
Copying an Allow / Prohibit Matrix configuration
To copy an Allow / Prohibit Matrix configuration to a new configuration, perform the following steps.
1. Display the Allow / Prohibit Matrix configuration list.
2. Select a saved configuration or the active configuration from the list.
3. Click Copy.
The Allow / Prohibit Matrix Configuration dialog box displays.
4. In the dialog box, enter a name and description for the new configuration and click OK to save the
configuration to the target file; click Cancel to cancel copying the configuration.
The file name must be in alphanumeric characters and can contain only dashes or underscores as
special characters.
Deleting an Allow / Prohibit Matrix configuration
To delete a saved Allow / Prohibit Matrix configuration.
1. Display the Allow / Prohibit Matrix configuration list.
2. Select the saved configuration from the list.
3. Click Delete.
The Delete Allow / Prohibit Matrix Configuration confirmation dialog box displays.
4. Click Yes to delete the selected configuration; click No to cancel the deletion.
CUP logical path configuration
The logical reporting path is a CUP mechanism for sending FRU-failure type reports to a FICON Logical
Path via the FICON Protocol.
Viewing CUP logical path configurations
To display a list of CUP logical path configurations, perform the following steps.
1. Select a FICON-enabled switch from the Fabric Tree.
2. Select Configure > Switch Admin.
3. Click Show Advanced Mode to see all the available tabs and options.
4. Select the FICON CUP tab.
The FICON CUP page displays the FICON Management Server page in front. All attributes on this
page are read-only until FMS mode is enabled.
5. Click the CUP Logical Paths subtab.
Copying an Allow / Prohibit Matrix configuration
Web Tools Administrator's Guide 243
53-1003169-01