Brocade Web Tools Administrators Guide (Supporting Fabric OS v7.3.0) - Manual (Page 57)

FIGURE 9 Blade tab
3. Select Blade Action > Enable Blade for each blade you want to enable, or Blade Action >
Disable Blade to disable a blade, and click Yes in the confirmation dialog box.
Disabling a blade does not turn off the blade, it disables the ports on the blade. You cannot enable or
disable the CP blades.
Setting a slot-level IP address
To set an IP address, perform the following steps.
1. Open the Switch Administration window as described in Opening the Switch Administration window
on page 52.
2. Select the Blade tab.
3. Click Set IP address.
4. Select a slot number from the list.
5. Enter the IP address, subnet mask, and Gateway IP address.
6. Select a type from the list.
7. Click Add to add the new entry to the table.
When you click Add, the values remain in the fields. The Clear Gateway and Clear IP buttons are
available for clearing fields in the table.
Setting a slot-level IP address
Web Tools Administrator's Guide 57
53-1003169-01