Brocade Web Tools Administrators Guide (Supporting Fabric OS v7.3.0) - Manual (Page 52)

FIGURE 7 Switch Administration window, Switch tab, Basic mode
With the exception of switch time, information displayed in the Switch Administration window is not
updated automatically by Web Tools. To update the information displayed in the Switch
Administration window, click the Refresh button.
ATTENTION
Most changes you make in the Switch Administration window are buffered, and are not applied to
the switch until you save the changes. If you close the Switch Administration window without saving
your changes, your changes are lost. To save the buffered changes you make in the Switch
Administration window to the switch, click Apply before closing the module or before switching to
another tab. The License tab, Firmware Download tab, and the Security Policies tab are
exceptions. The changes you make on these tabs take effect immediately and there is no Apply
button. There is an Apply button in all the subtabs of security policies except ACL.
You can also use Telnet commands to perform management tasks. Refer to "Opening a Telnet or SSH
client window" on page 28 for information on how to launch a Telnet window using Web Tools.
Opening the Switch Administration window
Most of the management procedures in this chapter are performed from the Switch Administration
window.
To open the Switch Administration window, perform the following steps.
Opening the Switch Administration window
52 Web Tools Administrator's Guide
53-1003169-01