Brocade Web Tools Administrators Guide (Supporting Fabric OS v7.3.0) - Manual (Page 112)

FIGURE 15 Port swapping index
Configuring port binding
To bind a port or ports, perform the following steps.
1. Select a port in the Switch View to open the Port Admin tab.
2. Select the FC Ports tab.
3. Select View > Advanced.
4. From the table, select the port or ports you want to bind.
5. Select Binding > Bind PID from the Actions list.
NOTE
If a port is already bound, a warning message is displayed that the port ID is already bound. The
bound port is not listed in the Bind PID dialog box.
6. Enter the middle byte to be set in the Start Address field.
7. Select the ports under Selected Ports for which you want to set the middle bytes and click the right
arrow as shown in the following figure.
For the selected ports, the middle bytes are assigned sequentially.
Configuring port binding
112 Web Tools Administrator's Guide
53-1003169-01